User guide

5-30 Chapter 5: Software support
The task Create only creates the combination of stripped and mirrored
set without creating a backup. Create and duplicate creates both
combination of stripped and mirrored sets with backup.
4. Select Select Disk Drives, then press <Enter>. Use arrow keys to
select disk drive/s, then press <Enter> to mark selected drive. (An
asterisk is placed before a selected drive.)
5. Select Start Create Process and press <Enter> to setup hard disk for
RAID system. The following confirmation message appears:
Press “Y” to confirm or “N” to return to the configuration options.
5.4.3.3 RAID 0+1 (Safety and Performance)
1. Select the second option item Array Mode, then press the <Enter> key.
The RAID system setting pop-up menu appears.
2. Select RAID 0/1 from the menu and press <Enter>. Select next task
from pop-up menu.
The same confirmation message appears when the Auto Setup for
Data Security option is selected.
The data on the selected disks will
be destroyed. Continue? Press Y/N
RAID 0 for performance
RAID 1 for data protection
RAID 0/1
RAID SPAN for capacity
RAID 0/1
Create only
Create and duplicate
Create only
3. Select task and press <Enter>. The screen returns to Create Array
menu items. From this point, you may choose to auto-configure the
RAID array by selecting Auto Setup (Safe, Performance) or manually
configure the RAID array for mirrored sets. If you want to manually
configure the RAID array continue with next step. Screen reference on
Auto Setup for Data Security can be found in step #6.
4. Select Select Disk Drives, then press <Enter>. Use arrow keys to
select disk drive/s, then press <Enter> to mark selected drive.