User guide

5-36

Chapter 5: Software support

2. Select the stripe value for the RAID 0 array by scrolling through the

available values by using the Up and Down arrow keys and

pressing the <Enter> key.

3. The available values range from 8 KB to 128 KB increments. The

strip value should be chosen based on the planned drive usage.

Some suggested selections are listed below. The default selection

is 64 KB.

• 16 KB - low disk usage

• 64 KB - typical disk usage

• 128 KB - performance disk usage

4. Press the <Enter> key again to the Create Volume prompt to create

the array. Confirm this selection by pressing the <Y> key after the

prompt.

Are you sure you want to create this volume (Y/N)

5. Scroll to option 4 Exit and press the <Enter> key to exit the RAID

configuration utility. Confirm the exit by pressing <Y> key.

5.5.5 Deleting a RAID Volume

[

HELP

]

Deleting a volume will destroy the volume data on the drive(s) and

cause any member disks to become available as non-RAID disks.

WARNING:EXISTING DATA WITHING THIS VOLUME WILL BE LOST AND NON-RECOVERABLE

Intel(R) Integrated RAID for Serial ATA - RAID Configuration Utility

[

DELETE ARRAY MENU

]

[ ]-Change

[TAB]-Next

[<ESC>]-Previous Menu

[<DEL>]-Delete Volume

Name Level Drives  Capacity Status Bootable

RAID_Volume1 RAID0(Stripe) 2 37.2GB Normal Yes

Take caution in using this option; All data on the RAID drives will be

lost!