Owner manual

ASUS P4P800 SE motherboard 2-25
2.7.2 Internal connectors
1. Floppy disk drive connector (34-1 pin FLOPPY)
This connector supports the provided floppy drive ribbon cable. After
connecting one end to the motherboard, connect the other end to the
floppy drive. (Pin 5 is removed to prevent incorrect insertion when
using ribbon cables with pin 5 plug).
P4P800 SE
®
NOTE: Orient the red markings o
n
the floppy ribbon cable to PIN 1.
P4P800 SE Floppy Disk Drive Connector
PIN 1
FLOPPY1
1. Follow the hard disk drive documentation when setting the device
in master or slave mode.
2. Pin 20 on each IDE connector is removed to match the covered
hole on the UltraDMA cable connector. This prevents incorrect
orientation when you connect the cables.
3. The hole near the blue connector on the UltraDMA cable is
intentional.
P4P800 SE
®
P4P800 SE IDE Connectors
NOTE: Orient the red marking
s
(usually zigzag) on the IDE
ribbon cable to PIN 1.
SEC_IDE1 PRI_IDE1
PIN 1
2. IDE connectors (40-1 pin PRI_IDE1, SEC_IDE1)
This connector supports the provided UltraDMA100/66 IDE hard disk
ribbon cable. Connect the cable’s blue connector to the primary
(recommended) or secondary IDE connector, then connect the gray
connector to the UltraDMA100/66 slave device (hard disk drive) and the
black connector to the UltraDMA100/66 master device.