Owner's manual

Software Guide
The first eleven lines after "Auto Configuration", which should
be set to "Enabled", are optimal settings for this mainboard that are
defined by the Auto Configuration feature, which configures the set
tings based on the CPU clock speed. All the other settings up to "Al
locate Memory Hole", with the exception of "Slow DRAM Refresh
(1:4)", are the recommended settings for this mainboard. You should
not change them unless you know what you are doing.
If you install SIMMs that use Slow Refresh DRAM, you should
set "Slow DRAM Refresh (1:4)" to "Enabled ".
You can enable the "Allocate Memory Hole" feature if you need
it for your (non-DOS) operating system, the documentation for it
should have instructions as to the required settings.
When you are done with this section, press the <Esc> key to go
back to the main screen. The next section covers Power Management
Setup.
3-13