Owner manual

2-302-30

2-30

Chapter 2: Hardware informationChapter 2: Hardware information

Chapter 2: Hardware information

3.3.

IDE RAID connectorsIDE RAID connectors

IDE RAID connectors

(40-1 pin PRI_RAID1 [red], SEC_RAID1 [red])(40-1 pin PRI_RAID1 [red], SEC_RAID1 [red])

(40-1 pin PRI_RAID1 [red], SEC_RAID1 [red])

These connectors are for Ultra ATA 133/100/66 signal cables. These

connectors support up to four IDE hard disk drives that can be

configured as a disk array through the onboard IDE RAID controller.

• Before creating a RAID set using Ultra ATA hard disks, make

sure that you have connected the Ultra ATA signal cable and

installed Ultra ATA 133/100/66 hard disk drives.

• The system automatically assigns the boot sequence of ATAPI

devices connected to the IDE RAID connectors.

• The ITE

8212F controller supports a maximum of 2 Ultra ATA hard

disk drives. In RAID 1 array, set both drives either as Master or Slave

before configuring a RAID 1 set.

These connectors are set to IDE mode by default. In IDE mode, you can

connect IDE devices to these connectors such as boot/data hard disk

drives or optical drives. If you intend to create an IDE RAID set using

these connectors, set the

ITE8212F ControllerITE8212F Controller

ITE8212F Controller item in the BIOS to

RAID Mode. See section “4.4.6 Onboard Devices Configuration” for

details.

P5GDC-V

P5GDC-V RAID connectors

NOTE: Orient the red markings

(usually zigzag) on the IDE

cable to PIN 1.

PRI_RAID1

PIN 1

SEC_RAID1