Installation Guide
Chapter1: QuickStart
16
English
1.7.4 PATA hard disk drive
1. Insert the PATA hard disk drive into
thebay.
2. Align the screws holes and secure
the disk drive with screws.
3. Orient and connect the signal cable
to the hard disk drive. The red stripe
on the cable is the pin1 end. Match
thedummy-proofnotchanddonot
force the cable into the connector.
4. Connect the 4‑pin power cable to
the connector at the back of the
hard disk drive.
5. Attch the other end of the signal
cable to the corresponding slot on
the motherboard.