Motherboard P5LD2-VM SE
T2727 © 2006 2
• • • • • • • • • • • • 6
• • • 7
2 3 1 2 Jumper Mode Jumper Free (Default) P5LD2-VM SE-TAYVZ 6 10839 11036 11XXX11XXX11 8 0
® ® ® ® ® ® ® ® 9
1-1
® ® ® ® 1-2
® 1-3
1-4
1-5
® P5LD2-VM SE SB_PWR P5LD2-VM SE Onboard LED 1-6 ON Standby Power OFF Powered Off
1-7 ® P5LD2-VM SE
CPU_FAN Super I/O PS/2KBMS T: Mouse B: Keyboard COM1 ® Intel GMCH 945G Top:Rear Speaker Out Center: Side Speaker Out Below: Center/Subwoofer Top:Line In Center:Line Out Below:Mic In FLOPPY EATXPWR LAN_USB34 DDR2 DIMM_B2 (64 bit,240-pin module) F_USB12 DDR2 DIMM_A2 (64 bit,240-pin module) VGA1 P5LD2-VM SE ® PARALLEL PORT LGA775 CHA_FAN Intel Gigabit LAN PRI_IDE PCIEX16 Intel FWH 4Mb ® Intel ICH7 SB_PWR PCI2 SATA3 CD PCIEX1_1 CR2032 3V Lithium Cell CMOS Power SATA1 1-8 SPDIF_O
• • • ® P5LD2-VM SE • P5LD2-VM SE CPU Socket 775 1-9
A B B A 1-10
A B 1-11
• • • 1-12
B A A B B A ® A P5LD2-VM SE B CPU_FAN CPU FAN PWM CPU FAN IN CPU FAN PWR GND P5LD2-VM SE CPU fan connector 1-13
B A A B 1-14 A B B A
1-15
• • • • 1-16 DIMM_B2 DIMM_A2 ® P5LD2-VM SE P5LD2-VM SE 240-pin DDR2 DIMM sockets
512MB 256MB 512MB 512MB 256MB 1024MB 512MB 512MB 512MB 1024MB 256MB 512MB 1024MB 256MB 512MB 512MB 512MB 1024MB 512MB 1024MB SAMSUNG SAMSUNG SAMSUNG Infineon Infineon Infineon Infineon CORSAIR MICRON MICRON MICRON MICRON Kingston Kingston Kingston Hynix Hynix Hynix ELPIDA ELPIDA M378T6553BG0-CD5 M378T3253FG0-CD5 M378T6453FG0-CD5 HYS64T64000GU-3.7-A HYS64T32000HU-3.7-A HYS64T128020HU-3.7-A HYS64T64000HU-3.
2 3 1 2 1 1 1-18
1-19
A 1-20 B C D E F G H
1-21
® P5LD2-VM SE CLRTC 1 2 P5LD2-VM SE Clear RTC RAM 1-22 Normal (Default) 2 3 Clear CMOS
1 2 3 4 5 6 7 8 14 13 12 11 10 9 1-23
1-24
® P5LD2-VM SE FLOPPY NOTE: Orient the red markings on the floppy ribbon cable to PIN 1. PIN 1 P5LD2-VM SE Floppy disk drive connector • ® P5LD2-VM SE • P5LD2-VM SE IDE connector PRI_IDE NOTE: Orient the red markings (usually zigzag) on the IDE ribbon cable to PIN 1.
1-26 ® P5LD2-VM SE P5LD2-VM SE Speaker out connector GND RSATA_TXP2 RSATA_TXN2 GND RSATA_RXP2 RSATA_RXN2 GND GND RSATA_TXP1 RSATA_TXN1 GND RSATA_RXP1 RSATA_RXN1 GND SATA3 SATA4 SATA1 SATA2 P5LD2-VM SE SATA connectors SPEAKER +5V GND GND Speak Out 1 ® GND RSATA_RXN4 RSATA_RXP4 GND RSATA_TXN4 RSATA_TXP4 GND GND RSATA_RXN3 RSATA_RXP3 GND RSATA_TXN3 RSATA_TXP3 GND P5LD2-VM SE
® P5LD2-VM SE CPU_FAN CPU FAN PWM CPU FAN IN CPU FAN PWR GND CHA_FAN GND +12V Rotation P5LD2-VM SE Fan connectors 1-27
SPDIFOUT GND +5V ® P5LD2-VM SE SPDIF_OUT ® P5LD2-VM SE P5LD2-VM SE Digital audio connector PLED PLEDNC PLED+ 1 P5LD2-VM SE Power LED connector 1-28
• • • ® P5LD2-VM SE EATXPWR P5LD2-VM SE ATX power +3 Volts +12 Volts GND +12V DC +12 Volts +5V Standby Power OK Ground GND +12V DC +5 Volts Ground +5 Volts Ground +3 Volts connectors +3 Volts ATX12V Ground +5 Volts +5 Volts +5 Volts -5 Volts Ground Ground Ground PSON# Ground -12 Volts +3 Volts 1-29
® P5LD2-VM SE CD Right Audio Channel Ground Ground Left Audio Channel P5LD2-VM SE USB 2.
MIC2 MICPWR Line out_R NC Line out_L NC AGND NC NC SENSE2_RETUR Legacy AC’97 compliant definition PORT1 L PORT1 R PORT2 R SENSE_SEND PORT2 L GND PRESENCE# SENSE1_RETUR P5LD2-VM SE ® AAFP Azalia compliant definition ® P5LD2-VM SE P5LD2-VM SE Analog front panel connector CHASSIS GND Chassis Signal (Default) +5VSB_MB P5LD2-VM SE Chassis intrusion connector 1-31
® P5LD2-VM SE F_PANEL PWRSW PWRLED GND PWR PWR_LEDPWR_LED+ Reset Ground IDE_LEDIDE_LED+ RESET IDE LED * Requires an ATX power supply.
2-1
2-2
EZFlash starting BIOS update Checking for floppy... EZFlash starting BIOS update Checking for floppy... Floppy found! Reading file “P5LD2VMS.ROM”. Completed. Start erasing.......| Start Programming...| Flashed successfully. Rebooting.
• • A:\>afudos /oOLDBIOS1.ROM A:\>afudos /oOLDBIOS1.ROM AMI Firmware Update Utility - Version 1.10 Copyright (C) 2002 American Megatrends, Inc. All rights reserved. Reading flash ..... done A:\> 2-4
A:\>afudos /iP5LD2VMS.ROM A:\>afudos /iP5LD2VMS.ROM AMI Firmware Update Utility - Version 1.10 Copyright (C) 2002 American Megatrends, Inc. All rights reserved. Reading file ..... done Erasing flash .... done Writing flash .... 0x0008CC00 (9%) A:\>afudos /iP5LD2VMS.ROM AMI Firmware Update Utility - Version 1.10 Copyright (C) 2002 American Megatrends, Inc. All rights reserved. Reading file ..... done Erasing flash .... done Writing flash .... 0x0008CC00 (9%) Verifying flash .. done A:\> 2-5
Bad BIOS checksum. Starting BIOS recovery... Checking for floppy... Bad BIOS checksum. Starting BIOS recovery... Checking for floppy... Floppy found! Reading file “P5LD2VMS.ROM”. Completed. Start flashing...
Bad BIOS checksum. Starting BIOS recovery... Checking for floppy... Bad BIOS checksum. Starting BIOS recovery... Checking for floppy... Floppy not found! Checking for CD-ROM... CD-ROM found. Reading file “P5LD2VMS.ROM”. Completed. Start flashing...
2-8
2-9
2-10
2-11
System Time System Date Legacy Diskette A Primary IDE Master Primary IDE Slave Third IDE Master Third IDE Slave Fourth IDE Master Fourth IDE Slave IDE Configuration System Information 2-12 : : : : : : [11:51:19] [Thu 06/10/2004] [1.44M, 3.5 in] Use [ENTER], [TAB] or [SHIFT-TAB] to select a field. [ST320413A] [Pioneer CD-ROM ATA] [Not Detected] [Not Detected] [Not Detected] [Not Detected] Use [+] or [-] to configure the System time.
System Time System Date Legacy Diskette A [11:51:19] [Thu 06/10/2004] [1.44M, 3.5 in] Primary IDE Master : [ST320413A] Primary IDE Slave : [Pioneer CD-ROM ATA] Third IDE Master : [Not Detected] Third IDE Slave : [Not Detected] Fourth IDE Master : [Not Detected] Fourth IDE Slave : [Not Detected] IDE Configuration Use [ENTER], [TAB] or [SHIFTTAB] to select a field. Use [+] or [-] to configure the System time.
System Time System Date Legacy Diskette A Primary IDE Master Primary IDE Slave Third IDE Master Third IDE Slave Fourth IDE Master Fourth IDE Slave IDE Configuration System Information 2-14 : : : : : : [11:51:19] [Thu 06/10/2004] [1.44M, 3.5 in] Use [ENTER], [TAB] or [SHIFT-TAB] to select a field. [ST320413A] [Pioneer CD-ROM ATA] [Not Detected] [Not Detected] [Not Detected] [Not Detected] Use [+] or [-] to configure the System time.
Primary IDE Master Device Vendor Size LBA Mode Block Mode PIO Mode Async DMA Ultra DMA SMART Monitoring : : : : : : : : : Hard Disk ST320413A 20.0GB Supported 16 Sectors Supported MultiWord DMA-2 Ultra DMA-5 Supported Select the type of device connected to the system.
IDE Configuration 2-16 Configure SATA As Onboard IDE Operate Mode Enhanced Mode Support On [Standard IDE] [Enhanced Mode] [S-ATA] IDE Detect Time Out (Sec) [35] Set to [Compatible Mode] when Legacy OS (i.e. WIN ME, 98, NT4.0, MS DOS is used. Set to [Enhanced Mode when Native OS) i.e. WIN 2000, WIN XP) is used.
2-17
AMIBIOS Version Build Date :0120 :05/11/05 Processor Type Speed Count :Genuine Intel(R) CPU 3.
Configure the USB support.
2-20 FSB 1066 266 MHZ FSB 800 200 MHz FSB 533 133 MHz
2-21
USB Configuration Module Version - 2.23.0-F.4 USB Devices Enabled: None USB Function Legacy USB Support USB 2.0 Controller USB 2.
Configure Advanced CPU settings Manufacturer: Brand String: Frequency : FSB Speed : Cache L1 Cache L2 Cache L3 Intel Genuine Intel(R) CPU 3.20GHz 3200 MHz 800 MHz : 16 KB : 1024 KB : 0 KB Sets the ratio between CPU Core Clock and the FSB Frequency. NOTE: If an invalid ratio is set in CMOS then actual and setpoint values may differ.
2-24
Advanced Chipset Settings Configure DRAM Timing by SPD [Enabled] Booting Graphic Adapter Priori [PCI Express/Int-VG] Internal Graphics Mode Select [Enabled, 8MB] Graphics memory type [Auto] 2-25
Configure Win627EHF Super IO Chipset HD Audio Controller [Enabled] Onboard PCIEX GbE LAN [Enabled] LAN Option ROM [Disabled] Serial Port1 Address Parallel Port Address Parallel Port Mode ECP Mode DMA Channel Parallel Port IRQ 2-26 [3F8/IRQ4] [378] [ECP] [DMA3] [IRQ7] Enable or disable High Definition Audio Controller.
2-27
Advanced PCI/PnP Settings WARNING: Setting wrong values in below sections may cause system to malfunction.
Suspend Mode ACPI 2.0 Support ACPI APIC Support [Auto] [No] [Enabled] Select the ACPI state used for System Suspend.
2-30 APM Configuration Power Button Mode [On/Off] Restore on AC Power Loss Power On By RTC Alarm Power On By External Modems Power On By PCI Devices Power On By PCIE Devices [Power Off] [Disabled] [Disabled] [Disabled] [Disabled] Go into On/Off or Suspend when Power button is pressed.
2-31
2-32 Hardware Monitor CPU Temperature MB Temperature [51ºC/122.5ºF] [41ºC/105.5ºF] CPU Fan Speed (RPM) CPU Q-Fan Control Chassis Fan Speed (RPM) [3813 RPM] [Disabled] [N/A] VCORE Voltage 3.3V Voltage 5V Voltage 12V Voltage [ 1.320V] [ 3.345V] [ 5.094V] [11.
2-33
Boot Settings Specifies the Boot Device Priority sequence Boot Device Priority Boot Settings Configuration Security Boot Device Priority 1st Boot Device 2nd Boot Device 3rd Boot Device 2-34 [1st FLOPPY DRIVE] [PM-ST330620A] [PS-Pioneer CD-ROM]
Boot Settings Configuration Quick Boot Full Screen Logo AddOn ROM Display Mode Bootup Num-Lock PS/2 Mouse Support Wait For ‘F1’ If Error Hit ‘DEL’ Message Display Interrupt 19 Capture [Enabled] [Enabled] [Force BIOS] [On] [Auto] [Enabled] [Enabled] [Disabled] Allows BIOS to skip certain tests while booting. This will decrease the time needed to boot the system.
Security Settings Supervisor Password User Password : Not Installed : Not Installed Change Supervisor Password 2-36 to change password. again to disabled password.
Security Settings Supervisor Password User Password : Not Installed : Not Installed Change Supervisor Password User Access Level Change User Password Clear User Password Password Check [Setup] Boot Sector Virus Protection [Disabled] [Full Access] 2-37
Exit Options Exit & Save Changes Exit & Discard Changes Discard Changes Load Setup Defaults 2-38
2-39
2-40
3-1
3-2
3-3
3-4
3-5
3-6
