Manual

1-28 Chapter 1: Product introduction
1.10.2 Internal connectors
1. Floppy disk drive connector (34-1 pin FLOPPY)
This connector is for the provided oppy disk drive (FDD) signal cable. Insert
one end of the cable to this connector, then connect the other end to the
signal connector at the back of the oppy disk drive.
Pin 5 on the connector is removed to prevent incorrect cable connection when
using an FDD cable with a covered Pin 5.
P5N-EMHDMI
R
P5N-EM HDMI Floppy Disk Drive Connector
NOTE:
Orient the red markings on
the floppy ribbon cable to PIN 1.
PIN 1
FLOPPY
2. Serial ATA connectors (7-pin SATA1, SATA2, SATA3, SATA4)
These connectors are for the Serial ATA signal cables for Serial ATA hard disk
drives.
P5N-EMHDMI
R
P5N-EM HDMI SATA Connectors
GND
RSATA_TXP2
RSATA_TXN2
GND
RSATA_RXP2
RSATA_RXN2
GND
SATA2
GND
RSATA
_TXP1
RSATA
_TXN1
GND
RSATA_
RXP1
RSATA_
RXN1
GND
SATA1
GND
RSATA
_TXP3
RSATA
_TXN3
GND
RSATA_
RXP3
RSATA_
RXN3
GND
SATA3
GND
RSATA
_TXP4
RSATA
_TXN4
GND
RSATA_
RXP4
RSATA_
RXN4
GND
SATA4