User's Manual

2-342-34
2-342-34
2-34
Chapter 2: Hardware informationChapter 2: Hardware information
Chapter 2: Hardware informationChapter 2: Hardware information
Chapter 2: Hardware information
15.15.
15.15.
15.
ATX power connectorsATX power connectors
ATX power connectorsATX power connectors
ATX power connectors
(24-pin EATXPWR, 4-pin ATX12V(24-pin EATXPWR, 4-pin ATX12V
(24-pin EATXPWR, 4-pin ATX12V(24-pin EATXPWR, 4-pin ATX12V
(24-pin EATXPWR, 4-pin ATX12V
, 4-pin EZ_PLUG, 4-pin EZ_PLUG
, 4-pin EZ_PLUG, 4-pin EZ_PLUG
, 4-pin EZ_PLUG
))
))
)
These connectors are for ATX power supply plugs. The power supply
plugs are designed to fit these connectors in only one orientation.
Find the proper orientation and push down firmly until the connectors
completely fit.
14.14.
14.14.
14.
Chassis intrusion connector (4-1 pin CHASSIS)Chassis intrusion connector (4-1 pin CHASSIS)
Chassis intrusion connector (4-1 pin CHASSIS)Chassis intrusion connector (4-1 pin CHASSIS)
Chassis intrusion connector (4-1 pin CHASSIS)
This connector is for a chassis-mounted intrusion detection sensor or
switch. Connect one end of the chassis intrusion sensor or switch
cable to this connector. The chassis intrusion sensor or switch sends a
high-level signal to this connector when a chassis component is
removed or replaced. The signal is then generated as a chassis
intrusion event.
By default, the pins labeled “Chassis Signal” and “Ground” are shorted
with a jumper cap. Remove the jumper caps only when you intend to
use the chassis intrusion detection feature.
P5ND2-SLI
®
P5ND2-SLI Series Chassis intrusion connector
CHASSIS
+5VSB_MB Chassis Signal GND
(Default
)
P5ND2-SLI
®
P5ND2-SLI Series ATX power connectors
EATXPWR
ATX12V
EZ_PLUG
+5V
EZ_DET
GND
+12V
+12V DC
GND
+12V DC
GND
+3 Volts
+3 Volts
Ground
+5 Volts
+5 Volts
Ground
Ground
Power OK
+5V Standby
+12 Volts
-5 Volts
+5 Volts
+3 Volts
-12 Volt
s
Ground
Ground
Ground
PSON#
Ground
+5 Volts
+12 Volts
+3 Volts
+5 Volts
Ground