Specifications

ASUS P5QL-EM 1-25
7. Front panel audio connector (10-1 pin AAFP)
This connector is for a chassis-mounted front panel audio I/O module that supports
either HD Audio or legacy AC`97 audio standard. Connect one end of the front panel
audio I/O module cable to this connector.
• We recommend that you connect a high-denition front panel audio module to this
connector to avail of the motherboard’s high-denition audio capability.
• By default, this connector is set to HD Audio. If you want to connect an AC97 front panel
audio module to this connector, set the Front Panel Support Type item in the BIOS to
[AC97]. See section “2.4.4 Chipset” for details.
P5QL-EM Front Panel Audio Connector
P5QL-EM
R
SENSE2_RETUR
PORT1L PORT1R PORT2R
SEBSE_SEND
PORT2L
SENSE1_RETUR PRESENSE# GND
AAFP
Legacy AC’97
compliant definition
NC
MIC2
Line out_R
Line out_L
NC
NC
MICPWR
NC AGND
HD-audio-compliant
pin definition
8. Chassis intrusion connector (4-1 pin CHASSIS)
This connector is for a chassis-mounted intrusion detection sensor or switch. Connect
one end of the chassis intrusion sensor or switch cable to this connector. The chassis
intrusion sensor or switch sends a high-level signal to this connector when a chassis
component is removed or replaced. The signal is then generated as a chassis intrusion
event.
By default, the pins labeled “Chassis Signal” and “Ground” are shorted with a jumper
cap. Remove the jumper caps only when you intend to use the chassis intrusion
detection feature.
P5QL-EM Intrusion Connector
P5QL-EM
R
CHASSIS
+5VSB_MB Chassis Signal GND
(Default)