User Guide

2-22 Chapter 2: Hardware Information

2.7.2 Internal connectors

1. Floppy disk drive connector (34-1 pin FLOPPY)

This connector is for the provided ﬂoppy disk drive (FDD) signal cable. Insert

one end of the cable to this connector, then connect the other end to the

signal connector at the back of the ﬂoppy disk drive.

Pin 5 on the connector is removed to prevent incorrect cable connection when

using an FDD cable with a covered Pin 5.

P5VD1-X

NOTE: Orient the red markings on

the floppy ribbon cable to PIN 1.

P5VD1-X Floppy disk drive connector

FLOPPY

PIN 1

2. Primary/Secondary IDE connector (40-1 pin PRI_IDE,

SEC_IDE)

This connector supports the provided UltraATA133 IDE hard disk ribbon cable.

Connect the cableʼs blue connector to the primary (recommended) or secondary

IDE connector, the black connector for the UltraATA133 master device.

1. Follow the hard disk drive documentation when setting the device in master

or slave mode.

2. Pin 20 on each IDE connector is removed to match the covered hole on the

UltraATA cable connector. This prevents incorrect orientation when you

connect the cables.

3. The hole near the blue connector on the UltraATA cable is intentional.

P5VD1-X

P5VD1-X IDE connectors

NOTE: Orient the red markings

(usually zigzag) on the IDE

ribbon cable to PIN 1.

PRI_IDE

PIN 1

SEC_IDE