User's Manual

3-12 Chapter 3: Software support
3.3.2 JMicron
®
RAID Conguration
The JMicron
®
Serial ATA controller allows you to congure RAID 0 and RAID 1 sets
on the external Serial ATA hard disk drives.
Before creating a RAID set
Prepare the following items:
1. Two HDDs, preferably with the same model and capacity.
2. A write-enabled oppy disk
3. Microsoft
®
Windows
®
OS installation disk (Windows 2000/XP/2003)
4. Motherboard support CD with JMB363 driver
Complete the following steps before you create a RAID set:
1. Install an internal Serial ATA hard disk drive and an external Serial ATA hard
disk drive on your system.
Install the internal Serial ATA hard disk drive to the SATA connector labeled
SATA_RAID1.
2. Set the JMicron RAID Controller item in the BIOS to [RAID]. See section
“2.4.4 Onboard Devices Conguration” for details.
3. Enter the JMB363 RAID BIOS utility to set up your RAID conguration.
4. Create a JMB363 RAID driver disk for Windows
®
OS installation. See section
“3.4 Creating a RAID driver disk” for details.
5. Install the JMB363 driver after the Windows
®
OS had been installed.
F1:Help ↑↓ : Select Item -/+: Change Value F5: Setup Defaults
ESC: Exit →←: Select Menu Enter: Select SubMenu F10: Save and Exit
Select Menu
Item Specic Help
Press [Enter] to set
Onboard Devices Conguration
JMicron RAID controller
[IDE]
SATA Controller [Enabled]
SATA Controller Mode [IDE]
Ex-SATA/PCI-E*1 Option [Ex-SATA]
HDA Controller [Auto]
Onboard LAN [Enabled]
Onboard LAN Boot ROM [Disabled]
Serial Port1 Address [3F8/IRQ4]
Parallel Port Address [378/IRQ7]
Parallel Port Mode [Bi-Directional]
ECP Mode Use DMA [3]
Phoenix-Award BIOS CMOS Setup Utility
Advanced