User's Manual
1-28 Chapter 1: Product introduction
9. USB 2.0 ports 1 and 2. These two 4-pin Universal Serial Bus (USB) ports are
available for connecting USB 2.0 devices.
10. USB 2.0 ports 3 and 4
(Only for P5VD2-VM). These two
4-pin Universal Serial Bus (USB) ports are available for connecting USB 2.0
devices.
11. VGA port. This 15-pin VGA port connects to a VGA monitor.
12. External SATA port. This port connects to an external Serial ATA hard disk
drive. To congure a RAID 0, a RAID 1, or a JBOD set, install an external
Serial ATA hard disk drive and an internal Serial ATA hard disk drive to the
SATA connector labeled SATA_RAID1.
7. Antenna jack
(Only for P5V-VM SE DH). This port is on the onboard wireless
LAN module that allows you to set up a wireless network and exchange
information with other wireless devices without tangling cables and wires.
Connect the moveable omni-directional antenna to this jack.
8. WIFI-AP Solo LED indicator
(Only for P5V-VM SE DH). The WIFI-AP Solo
comes with a green data transmission LED (AIR). Refer to the ASUS WiFi-AP
Solo user guide.
13. PS/2 keyboard port (purple). This port is for a PS/2 keyboard.
The external SATA port supports
external Serial ATA 1.5 and 3 Gb/s
devices. Longer cables support
higher power requirements to
deliver signal up to two meters
away, and enables improved
hot-swap function.
• DO NOT insert a different connector to this port.
• DO NOT unplug the external Serial ATA box when a RAID 0 or JBOD is
congured.
• PCI-E x1 and eSATA cannot be used simultaneously.
• Before creating a RAID set using Serial ATA hard disks, make sure that you
have connected the Serial ATA signal cable and installed Serial ATA hard
disk drives; otherwise, you cannot enter the JMicron RAID utility and SATA
BIOS setup during POST.
• If you intend to create a RAID conguration using this connector, set the
JMicron RAID controller item in the BIOS to [RAID Mode]. See section
“2.4.4 Onboard Devices Conguration” for details.