Installation guide

¿ù»~ ! ©|¥¼©w¸q¼Ë¦¡¡C
2
The P6300 Series Notebook PC is normally shipped out with Windows 95B OEM Service Release 2.1 operating
system installed. If you need to install or reinstall other operating systems, you may have to refer to the following
items to have your hard disk prepared for installation.
To Create a Partition for Suspend-to-Disk
• Insert a DOS boot system diskette with "PHDISK" utility inside to drive A:.
• Type "PHDISK/CREATE 150000" then press [Enter].
Note : The PHDISK utility will create a partition of approximately 150MB reserved space in your
hard disk which will be dedicated to the function of "Suspend-to-Disk" with the "Power
Management" mode enabled.
The reason we specify 150MB is because that the maximum memory the P6000 can support is
144Mbytes, thus the 150MB Suspend-to-Disk partition on the HDD guarantees all data in
memory can be stored on this partition. If you do not specify a figure, PHDISK will create a
partition which is a little bit bigger than the system memory size for you.
To Create DOS or Non-DOS Partitions
• Insert a DOS boot system diskette with "FDISK" program inside into the floppy drive.
• Type "FDISK" then press [Enter].
• Create a primary partition and activate it as instructed by the on-screen menu, and also create
extended partitions if needed.