Specifications
Table Of Contents
- Notices
- Safety information
- About this guide
- P8H61-M LE Series specifications summary
- Chapter 1
- Product introduction
- Chapter 2
- BIOS information
- 2.1 Managing and updating your BIOS
- 2.2 BIOS setup program
- 2.3 Main menu
- 2.4 Ai Tweaker menu
- 2.4.1 Ai Overclock Tuner [Auto]
- 2.4.2 Memory Frequency [Auto]
- 2.4.3 iGPU Max. Frequency [Auto]
- 2.4.4 EPU Power Saving Mode [Disabled]
- 2.4.5 GPU Boost [OK]
- 2.4.6 DRAM Timing Control
- 2.4.7 CPU Power Management
- 2.4.8 CPU Offset Mode Sign [+]
- 2.4.9 iGPU Offset Mode Sign [+]
- 2.4.10 DRAM Voltage [Auto]
- 2.4.11 VCCIO Voltage [Auto]
- 2.4.12 CPU PLL Voltage [Auto]
- 2.4.13 PCH Voltage [Auto]
- 2.4.14 CPU Spread Spectrum [Auto]
- 2.5 Advanced menu
- 2.6 Monitor menu
- 2.7 Boot menu
- 2.8 Tools menu
- 2.9 Exit menu
1-13Chapter 1: Product introduction
3. Connect the CPU fan cable to the connector on the motherboard labeled CPU_FAN.
Do not forget to connect the CPU fan connector! Hardware monitoring errors can occur if
you fail to plug this connector.
1.6.3 Uninstalling the CPU heatsink and fan
To uninstall the CPU heatsink and fan:
1. Disconnect the CPU fan cable from the connector on the motherboard.
2. Rotate each fastener counterclockwise.
3. Pull up two fasteners at a time in a diagonal sequence to disengage the heatsink and
fan assembly from the motherboard.
A
A
B
B
A
A
B
B
CPU_FAN
CPU FAN PWM
CPU FAN IN
CPU FAN PWR
GND
P8H61-M LE/USB3
P8H61-M LE/USB3 CPU fan connector