Specifications
Table Of Contents
- Notices
- Safety information
- About this guide
- P8H61-M LE Series specifications summary
- Chapter 1
- Product introduction
- Chapter 2
- BIOS information
- 2.1 Managing and updating your BIOS
- 2.2 BIOS setup program
- 2.3 Main menu
- 2.4 Ai Tweaker menu
- 2.4.1 Ai Overclock Tuner [Auto]
- 2.4.2 Memory Frequency [Auto]
- 2.4.3 iGPU Max. Frequency [Auto]
- 2.4.4 EPU Power Saving Mode [Disabled]
- 2.4.5 GPU Boost [OK]
- 2.4.6 DRAM Timing Control
- 2.4.7 CPU Power Management
- 2.4.8 CPU Offset Mode Sign [+]
- 2.4.9 iGPU Offset Mode Sign [+]
- 2.4.10 DRAM Voltage [Auto]
- 2.4.11 VCCIO Voltage [Auto]
- 2.4.12 CPU PLL Voltage [Auto]
- 2.4.13 PCH Voltage [Auto]
- 2.4.14 CPU Spread Spectrum [Auto]
- 2.5 Advanced menu
- 2.6 Monitor menu
- 2.7 Boot menu
- 2.8 Tools menu
- 2.9 Exit menu
1-23Chapter 1: Product introduction
• For a fully congured system, we recommend that you use a power supply unit (PSU)
that complies with ATX 12 V Specication 2.0 (or later version) and provides a minimum
power of 350 W.
•
DO NOT forget to connect the 4-pin ATX +12V power plug. Otherwise, the system will
not boot up.
• We recommend that you use a PSU with higher power output when conguring a
system with more power-consuming devices. The system may become unstable or may
not boot up if the power is inadequate.
•
If you are uncertain about the minimum power supply requirement for your system,
refer to the Recommended Power Supply Wattage Calculator at http://support.asus.
com/PowerSupplyCalculator/PSCalculator.aspx?SLanguage=en-us for details.
2. ATX power connectors (24-pin EATXPWR, 4-pin ATX12V)
These connectors are for ATX power supply plugs. The power supply plugs are
designed to t these connectors in only one orientation. Find the proper orientation and
push down rmly until the connectors completely t.
P8H61-M LE/USB3
P8H61-M LE/USB3 ATX power connectors
EATXPWR
PIN 1
GND
+5 Volts
+5 Volts
+5 Volts
-5 Volts
GND
GND
GND
PSON#
GND
-12 Volts
+3 Volts
+3 Volts
+12 Volts
+12 Volts
+5V Standby
Power OK
GND
+5 Volts
GND
+5 Volts
GND
+3 Volts
+3 Volts
ATX12V
PIN 1
+12V DC
+12V DC
GND
GND
3. Serial port connector (10-1 pin COM1)
This connector is for a serial (COM) port. Connect the serial port module cable to this
connector, then install the module to a slot opening at the back of the system chassis.
The COM module is purchased separately.
P8H61-M LE/USB3
P8H61-M LE/USB3 Serial port (COM1) connector
PIN 1
COM1