User's Manual
Table Of Contents
- Contents
- Chapter 1: Product introduction
- Chapter 2: Hardware information
- 2.1 Before you proceed
- 2.2 Motherboard overview
- 2.3 Building your computer system
- 2.3.1 Additional tools and components to build a PC system
- 2.3.2 CPU installation
- 2.3.3 CPU heatsink and fan assembly installation
- 2.3.4 DIMM installation
- 2.3.5 Motherboard installation
- 2.3.6 ATX Power connection
- 2.3.7 SATA device connection
- 2.3.8 Front I/O Connector
- 2.3.9 Expension Card installation
- 2.3.10 USB BIOS Flashback
- 2.3.11 Rear panel connection
- 2.3.12 Audio I/O connections
- 2.4 Starting up for the first time
- 2.5 Turning off the computer
- Chapter 3: BIOS setup
- Chapter 4: Software support
- 4.1 Installing an operating system
- 4.2 Support DVD information
- 4.3 Software information
- 4.4 RAID configurations
- 4.4.1 RAID definitions
- 4.4.2 Installing Serial ATA hard disks
- 4.4.3 Setting the RAID item in BIOS
- 4.4.4 Intel® Rapid Storage Technology Option ROM utility
- 4.4.5 Introduction to Intel® 2012 Desktop responsiveness technologies
- 4.4.6 Intel® Smart Response Technology
- 4.4.7 Intel® Rapid Start Technology
- 4.4.8 Intel® Smart Connect Technology
- 4.5 Creating a RAID driver disk
- Chapter 5: Multiple GPU technology support
- Appendices
3-20
Chapter 3: BIOS setup
Chapter 3
S.M.A.R.T. Status Check [Enabled]
S.M.A.R.T. (Self-Monitoring, Analysis and Reporting Technology) is a monitor system. When
read/write of your hard disk errors occur, this feature allows the hard disk to report warning
messages during the POST.
Conguration options: [Enabled] [Disabled]
Hot Plug [Disabled]
These items appear only when you set the SATA mode item to [AHCI Mode] or [RAID Mode],
and allow you to enable/disable SATA Hot Plug Support.
Conguration options: [Disabled] [Enabled]
3.5.4 System Agent Conguration
Memory Remap Feature [Enabled]
[Enabled] Allow you to enable remapping the memory above 4GB.
[Disabled] Disables this function.
Graphics Conguration
Primary Display [Auto]
Allows you to select a primary display from IGFX, PEG, or PCI graphic devices, or
select SG for switchable GFX.
Conguration options: [Auto] [IGFX] [PEG]
iGPU Memory [32M]
This item select DVMT 5.0 pre-allocated graphic memory size, used by the internal
graphic device.
Conguration options: [32M] [64M] [96M]~[1024M]
Render Standby [Enabled]
Allows you to enabled or disabled render standby support.
Conguration options: [Disabled] [Enabled]
iGPU Multi-Monitor [Enabled]
Allows you to enable the iGPU Multi-Monitor. For Lucid Virtu MVP function supports,
set this item to [Enabled] to empower both integrated and discrete graphics. iGPU
shared system memory size is xed in 64MB
Conguration options: [Disabled] [Enabled]