User Manual

2-28
Chapter 2: Hardware information
4. RAID conguration utility selection (3-pin RAID_SEL1)
This jumper allows you to select the RAID conguration utility for creating
disk arrays. Place the jumper caps over pins 1–2 if you want to use a Third-
Party Setup Utility (default). Otherwise, place the jumper caps to pins 2–3 to
use the Intel
®
Rapid Storage Technology.
5. Platform Enviromental Control Interface Setting (3-pin PECI1)*
When ASMB7-iKVM is installed, set to pins 2-3 for correct sensor information
of the Platform Environmental Control Interface
(
PECI). Set to pins 1-2 if
ASMB7-iKVM is not installed.
*P9D-M and P9D-MV models only.