User Manual

3-8 Chapter 3: OSD (On-Screen Display) menu
• SplendidDemoMode: Splits the screen into two for Splendid modes
comparison. (DCI-P3 Mode and sRGB Mode only)
To activate this function, you need to do the following: turn off PIP/PBP, turn off
Ambient Effect and disable HDR on your device.
• ECOMode: Reduces power consumption.
• To activate this function, you need to do the following: disable HDR on
your device.
• When ECO Mode is on, the following function(s) are not user-congurable:
Brightness, Contrast.
• Adaptive-Sync(DisplayPort/Thunderbolt only): Allows an Adaptive-Sync
supported* graphics source to dynamically adjust display refresh rate
based on typical content frame rates for power efcient, virtually stutter
free and low-latency display update.
* Adaptive-Sync can only be activated within 40Hz ~ 60Hz.
* For supported GPUs, minimum PC system and driver requirements, please
contact the GPU manufactures.
To activate this function, you need to do the following: turn off Motion Sync, turn
off PIP/PBP mode and set DisplayPort Stream to DisplayPort 1.2.
• DynamicDimming: Synchronizes with contents while contrast changing
to execute backlight dynamic dimming .
• To activate this function, you need to do the following: turn off PIP/PBP.
• Dynamic Dimming is automatically activated when HDR is on.
• HDR:
* “HDR 1” .
* “HDR 2” complies with ULTRA HD PREMIUM™.
• PowerSaving:
* “1st Level” allows the USB downstream ports/Thunderbolt ports
to charge external devices when the monitor enters power saving
mode.
* “Deep Level” does not allow all ports to charge external devices
and keeps Thunderbolt and USB signals from being automatically
detected when the monitor enters power saving mode to achieve
the maximum benefit of saving power.
• OSDSetup:
* Adjusts the OSD timeout from 10 to 120 seconds.
* Enables or disables the DDC/CI function.