User Manual
Table Of Contents
- About this manual
- Chapter 1: Getting to know your Embedded Computer
- Chapter 2: Using your Embedded Computer
- Chapter 3: Upgrading your Embedded Computer
- 3.1 Removing the bottom cover
- 3.2 Replacing the bottom cover
- 3.3 Installing a nano SIM card (optional)
- 3.4 Installing a microSD card (optional)
- 3.5 Installing an M.2 (E-key) module
- 3.6 Installing an M.2 (M-key) module
- 3.7 Installing an mPCIe module
- 3.8 Installing antennas (optional)
- 3.9 Installing wall mount brackets (optional)
- 3.10 Mounting to a surface (optional)
- 3.11 Installing DIN rail clips (optional)
- 3.12 Installing the terminal block (optional)
- Chapter 4: Setting up your Embedded Computer
- Appendix
38
PE Series
3.3 Installing a nano SIM card
(optional)
Your embedded computer comes with two (2) nano SIM card slots.
NOTE: Nano SIM cards are purchased separately.
1. Remove the two (2) screws securing the metal slot cover (A), and then
remove the cover (B).
2. Insert your nano SIM card(s) into the nano SIM card slot(s) with the gold
contacts facing up. Make sure that each card is pushed all the way into
its card slot.