User Manual
Table Of Contents
- About this manual
- Chapter 1: Getting to know your Embedded Computer
- Chapter 2: Using your Embedded Computer
- Chapter 3: Upgrading your Embedded Computer
- 3.1 Removing the bottom cover
- 3.2 Replacing the bottom cover
- 3.3 Installing a nano SIM card (optional)
- 3.4 Installing a microSD card (optional)
- 3.5 Installing an M.2 (E-key) module
- 3.6 Installing an M.2 (M-key) module
- 3.7 Installing an mPCIe module
- 3.8 Installing antennas (optional)
- 3.9 Installing wall mount brackets (optional)
- 3.10 Mounting to a surface (optional)
- 3.11 Installing DIN rail clips (optional)
- 3.12 Installing the terminal block (optional)
- Chapter 4: Setting up your Embedded Computer
- Appendix
40
PE Series
2. Insert your microSD card into the microSD card slot with the gold
contacts facing up. Make sure that the card is pushed all the way into
the card slot.
3.4 Installing a microSD card
(optional)
Your Embedded Computer comes with one (1) microSD card slot.
NOTE: The microSD card is purchased separately.
1. Remove the two (2) screws securing the slot cover (A), and then remove
the cover (B).