User Manual
Table Of Contents
- About this manual
- Chapter 1: Getting to know your Embedded Computer
- Chapter 2: Using your Embedded Computer
- Chapter 3: Upgrading your Embedded Computer
- 3.1 Removing the bottom cover
- 3.2 Replacing the bottom cover
- 3.3 Installing a nano SIM card (optional)
- 3.4 Installing a microSD card (optional)
- 3.5 Installing an M.2 (E-key) module
- 3.6 Installing an M.2 (M-key) module
- 3.7 Installing an mPCIe module
- 3.8 Installing antennas (optional)
- 3.9 Installing wall mount brackets (optional)
- 3.10 Mounting to a surface (optional)
- 3.11 Installing DIN rail clips (optional)
- 3.12 Installing the terminal block (optional)
- Chapter 4: Setting up your Embedded Computer
- Appendix
PE Series
47
3.8 Installing antennas (optional)
You may install antennas to the five (5) antenna jacks located on the rear
panel. The installed antennas can be connected to an LTE card installed in
the mPCIe/mSATA slot or to a wireless card installed in the M.2 Wi-Fi slot.
NOTE:
• It is recommended that you install the antennas as shown in the
diagram below.
• LTE antennas are flatter and slightly longer than the Wi-Fi and GPS
antennas.
Antenna jack locations