User’s Manual
Table Of Contents
- About this manual
- Chapter 1: Getting to know your Embedded Computer
- Chapter 2: Using your Embedded Computer
- Chapter 3: Upgrading your Embedded Computer
- 3.1 Removing the bottom cover
- 3.2 Replacing the bottom cover
- 3.3 Removing the top cover
- 3.4 Replacing the top cover
- 3.5 Installing a nano SIM card (Front panel)
- 3.6 Installing an SD card (Top side)
- 3.7 Installing a wireless card to the M.2 slot (Top side)
- 3.8 Installing an mPCIe / mSATA module (Bottom side)
- 3.9 Installing antennas (optional)
- 3.10 Installing the wall mount
- 3.11 Installing DIN rail clips (optional)
- 3.12 Installing the terminal block (optional)
- Chapter 4: Setting up your Embedded Computer
- Appendix
18
PE Series
1.2.2 Pico-ITX motherboard
1. Boot Mode switch
The Boot Mode switch allows you to configure between different boot
modes and the location to boot from. Please refer to the table below
for the different boot modes.
Boot Mode
Boot type
1 2
OFF ON Serial Downloader
ON OFF Internal Boot (default)
Boot Mode
Boot type
3 4
OFF ON eMMC (default)
ON OFF SD