User’s Manual
Table Of Contents
- About this manual
- Chapter 1: Getting to know your Embedded Computer
- Chapter 2: Using your Embedded Computer
- Chapter 3: Upgrading your Embedded Computer
- 3.1 Removing the bottom cover
- 3.2 Replacing the bottom cover
- 3.3 Removing the top cover
- 3.4 Replacing the top cover
- 3.5 Installing a nano SIM card (Front panel)
- 3.6 Installing an SD card (Top side)
- 3.7 Installing a wireless card to the M.2 slot (Top side)
- 3.8 Installing an mPCIe / mSATA module (Bottom side)
- 3.9 Installing antennas (optional)
- 3.10 Installing the wall mount
- 3.11 Installing DIN rail clips (optional)
- 3.12 Installing the terminal block (optional)
- Chapter 4: Setting up your Embedded Computer
- Appendix
PE Series
29
NOTE:
Refer to the following for power adapter and system power requirements:
65W Power adapter
• Input voltage: 100-240 Vac
• Input frequency: 50-60 Hz
• Rated output current: 5.41 A / 3.42 A (65.0 W)
• Rated output voltage: 12-19 Vdc
System
• Rated voltage: 19 Vdc; rated current: 3.42 A
• Rated voltage: 12 Vdc; rated current: 5.41 A
• Rated voltage: 12-24 Vdc; rated current: 5.41 A-2.7 A
WARNING!
• Do not use power adapters or batteries from other devices to
reduce the risk of injury to persons due to fire or explosion. Use
only UL certified power adapters or batteries supplied by the
manufacturer or authorized retailers.
• Do not disable or remove the power cord grounding plug, the
grounding is an important safety feature.
• Ensure to plug the power cord into a grounded (earthed) electrical
outlet that is easily accessible at all times.
IMPORTANT!
• We strongly recommend that you use only the AC power adapter
and cable that came with your Embedded Computer.
• We strongly recommend that you use a grounded wall socket while
using your Embedded Computer.
• The socket outlet must be easily accessible and near your
Embedded Computer.
• To disconnect your Embedded Computer from its main power
supply, unplug your Embedded Computer from the power socket.