User’s Manual
Table Of Contents
- About this manual
- Chapter 1: Getting to know your Embedded Computer
- Chapter 2: Using your Embedded Computer
- Chapter 3: Upgrading your Embedded Computer
- 3.1 Removing the bottom cover
- 3.2 Replacing the bottom cover
- 3.3 Removing the top cover
- 3.4 Replacing the top cover
- 3.5 Installing a nano SIM card (Front panel)
- 3.6 Installing an SD card (Top side)
- 3.7 Installing a wireless card to the M.2 slot (Top side)
- 3.8 Installing an mPCIe / mSATA module (Bottom side)
- 3.9 Installing antennas (optional)
- 3.10 Installing the wall mount
- 3.11 Installing DIN rail clips (optional)
- 3.12 Installing the terminal block (optional)
- Chapter 4: Setting up your Embedded Computer
- Appendix
PE100A
63
Care during use
• Do not walk on the power cord or allow anything to rest on it.
• Do not spill water or any other liquids on your system.
• When the system is turned off, a small amount of electrical current still
flows. Always unplug the power cord from the power outlets before
cleaning the system.
• Use this product with care when operating at full load, as the product
may reach temperatures of up to 60˚C and the outer casing may reach
temperatures of up to 73˚C.
• If you encounter the following technical problems with the product,
unplug the power cord and contact a qualified service technician or
your retailer.
– The power cord or plug is damaged.
– Liquid has been spilled into the system.
– The system does not function properly even if you follow the
operating instructions.
– The system was dropped or the cabinet is damaged.
– The system performance changes.
NO DISASSEMBLY
The warranty does not apply to the products
that have been disassembled by users
Lithium-Ion Battery Warning
CAUTION: Danger of explosion if battery is incorrectly replaced.
Replace only with the same or equivalent type recommended
by the manufacturer. Dispose of used batteries according to the
manufacturer’s instructions.