User Manual
Table Of Contents
- About this manual
- Chapter 1: Getting to know your Embedded Computer
- Chapter 2: Using your Embedded Computer
- Chapter 3: Upgrading your Embedded Computer
- 3.1 Removing the bottom cover
- 3.2 Replacing the bottom cover
- 3.3 Installing a nano SIM card (optional)
- 3.4 Installing an M.2 (E-key) module
- 3.5 Installing an M.2 (M-key) module
- 3.6 Installing an M.2 (B-key) module
- 3.7 Installing antennas (optional)
- 3.8 Installing wall mount brackets (optional)
- 3.9 Mounting to a surface (optional)
- 3.10 Installing DIN rail clips (optional)
- 3.11 Installing the terminal block (optional)
- Chapter 4: Setting up your Embedded Computer
- Appendix
PE Series
11
Wi-Fi Signal LED
The Wi-Fi signal LED indicates whether the Embedded
Computer is connected to a wireless network.
Serial (COM/CAN) Signal LED
Each numbered LED indicates whether a device that is
connected to the corresponding serial (COM/CAN) port on
the back panel is communicating through the serial bus.
Power button
The power button allows you to turn the Embedded
Computer on or off. You can use the power button to put
your Embedded Computer to sleep mode or press it for
four (4) seconds to force shutdown.
USB 3.2 Gen 1 port
The USB 3.2 Gen 1 (Universal Serial Bus) port provides a
transfer rate up to 5 Gbit/s and a maximum of 5V/0.9A
output per port.
HDMI™ port
The integrated 19-pin HDMI™ (High Definition Multimedia
Interface) port with a receptacle connector to support
external display devices with the following resolutions:
SOM HDMI Spec Resolution
Jetson Orin™
NX
HDMI 2.0 Up to 3840x2160 @ 60Hz
Jetson Orin
Nano™
HDMI 1.4 Up to 3840x2160 @ 30Hz
LAN port
The 8-pin RJ-45 LAN port supports a standard Ethernet
cable for 10/100/1000Mbps connection to a local
network.