User Manual
Table Of Contents
- About this manual
- Chapter 1: Getting to know your Embedded Computer
- Chapter 2: Using your Embedded Computer
- Chapter 3: Upgrading your Embedded Computer
- 3.1 Removing the bottom cover
- 3.2 Replacing the bottom cover
- 3.3 Installing a nano SIM card (optional)
- 3.4 Installing an M.2 (E-key) module
- 3.5 Installing an M.2 (M-key) module
- 3.6 Installing an M.2 (B-key) module
- 3.7 Installing antennas (optional)
- 3.8 Installing wall mount brackets (optional)
- 3.9 Mounting to a surface (optional)
- 3.10 Installing DIN rail clips (optional)
- 3.11 Installing the terminal block (optional)
- Chapter 4: Setting up your Embedded Computer
- Appendix
16
PE Series
Serial (CAN) connector (on selected models)
The 9-pin CAN Bus serial connector allows you to connect
devices with a CAN interface, such as an electronic control
unit (ECU). Please refer to the table below for the pin
definitions of the CAN Bus connector.
1 2 3 4 5
6 7 8 9
Pin
CAN Bus
1 NA
2 CAN_L
3 GND
4 NA
5 GND
6 NA
7 CAN_H
8 NA
9 NA