User Manual
Table Of Contents
- About this manual
- Chapter 1: Getting to know your Embedded Computer
- Chapter 2: Using your Embedded Computer
- Chapter 3: Upgrading your Embedded Computer
- 3.1 Removing the bottom cover
- 3.2 Replacing the bottom cover
- 3.3 Installing a nano SIM card (optional)
- 3.4 Installing an M.2 (E-key) module
- 3.5 Installing an M.2 (M-key) module
- 3.6 Installing an M.2 (B-key) module
- 3.7 Installing antennas (optional)
- 3.8 Installing wall mount brackets (optional)
- 3.9 Mounting to a surface (optional)
- 3.10 Installing DIN rail clips (optional)
- 3.11 Installing the terminal block (optional)
- Chapter 4: Setting up your Embedded Computer
- Appendix
18
PE Series
1.1.3 Left view
Debug console port (on selected models)
This micro USB port allows you to connect a computer
to the integrated USB to UART debug console (baud rate
115200) using a micro USB cable. Once connected to a
computer, you can start debugging without the need for
additional equipment.
Flash (USB 2.0 micro USB) port
This flash (micro USB) port allows you to connect to a host
computer to flash the OS image.
NOTE: The features on this side are covered with a metal cover. Ensure
to remove and replace the metal cover when accessing these features.
For more information on removing and replacing the metal cover, refer
to Installing a nano SIM card.