User Manual
Table Of Contents
- About this manual
- Chapter 1: Getting to know your Embedded Computer
- Chapter 2: Using your Embedded Computer
- Chapter 3: Upgrading your Embedded Computer
- 3.1 Removing the bottom cover
- 3.2 Replacing the bottom cover
- 3.3 Installing a nano SIM card (optional)
- 3.4 Installing an M.2 (E-key) module
- 3.5 Installing an M.2 (M-key) module
- 3.6 Installing an M.2 (B-key) module
- 3.7 Installing antennas (optional)
- 3.8 Installing wall mount brackets (optional)
- 3.9 Mounting to a surface (optional)
- 3.10 Installing DIN rail clips (optional)
- 3.11 Installing the terminal block (optional)
- Chapter 4: Setting up your Embedded Computer
- Appendix
PE Series
25
5. RTC Battery connector
The RTC Battery connector allows you to connect a lithium CMOS
battery.
6. SO-DIMM slot
The SO-DIMM slot can support the following SOMs:
• NVIDIA® Jetson Orin Nano™
• NVIDIA® Jetson Orin™ NX
NOTE: Your Embedded Computer comes pre-installed with a System-
on-Module (SOM). The actual SOM installed may vary, depending on
your specifications.