User Manual
Table Of Contents
- About this manual
- Chapter 1: Getting to know your Embedded Computer
- Chapter 2: Using your Embedded Computer
- Chapter 3: Upgrading your Embedded Computer
- 3.1 Removing the bottom cover
- 3.2 Replacing the bottom cover
- 3.3 Installing a nano SIM card (optional)
- 3.4 Installing an M.2 (E-key) module
- 3.5 Installing an M.2 (M-key) module
- 3.6 Installing an M.2 (B-key) module
- 3.7 Installing antennas (optional)
- 3.8 Installing wall mount brackets (optional)
- 3.9 Mounting to a surface (optional)
- 3.10 Installing DIN rail clips (optional)
- 3.11 Installing the terminal block (optional)
- Chapter 4: Setting up your Embedded Computer
- Appendix
28
PE Series
2.1 Getting started
2.1.1 Connect the AC power adapter to your
Embedded Computer
To connect the AC power adapter to your Embedded Computer:
A. Connect the power cord to the AC power adapter.
B. Connect the AC power adapter to the terminal block power adapter.
C. Connect the 3-pin terminal block DC power connector into your
Embedded Computer’s power (DC) input.
D. Plug the AC power adapter into a 100 V~240 V power source.
NOTE: The power adapter is purchased separately and may vary in
appearance, depending on model and your region.