User Manual
Table Of Contents
- About this manual
- Chapter 1: Getting to know your Embedded Computer
- Chapter 2: Using your Embedded Computer
- Chapter 3: Upgrading your Embedded Computer
- 3.1 Removing the bottom cover
- 3.2 Replacing the bottom cover
- 3.3 Installing a nano SIM card (optional)
- 3.4 Installing an M.2 (E-key) module
- 3.5 Installing an M.2 (M-key) module
- 3.6 Installing an M.2 (B-key) module
- 3.7 Installing antennas (optional)
- 3.8 Installing wall mount brackets (optional)
- 3.9 Mounting to a surface (optional)
- 3.10 Installing DIN rail clips (optional)
- 3.11 Installing the terminal block (optional)
- Chapter 4: Setting up your Embedded Computer
- Appendix
30
PE Series
2.1.2 Connect a display panel to your Embedded
Computer
You can connect a display panel or projector to your Embedded Computer
that has the following connector(s):
• HDMI™ connector
Connect display via HDMI™ port
To connect a display panel to your Embedded Computer:
Connect one end of an HDMI™ cable to an external display, and the other
end of the cable to your Embedded Computer’s HDMI™ port.