User Manual
Table Of Contents
- About this manual
- Chapter 1: Getting to know your Embedded Computer
- Chapter 2: Using your Embedded Computer
- Chapter 3: Upgrading your Embedded Computer
- 3.1 Removing the bottom cover
- 3.2 Replacing the bottom cover
- 3.3 Installing a nano SIM card (optional)
- 3.4 Installing an M.2 (E-key) module
- 3.5 Installing an M.2 (M-key) module
- 3.6 Installing an M.2 (B-key) module
- 3.7 Installing antennas (optional)
- 3.8 Installing wall mount brackets (optional)
- 3.9 Mounting to a surface (optional)
- 3.10 Installing DIN rail clips (optional)
- 3.11 Installing the terminal block (optional)
- Chapter 4: Setting up your Embedded Computer
- Appendix
36
PE Series
3.1 Removing the bottom cover
IMPORTANT!
• Ensure that your hands are dry before proceeding with the rest
of the installation process. Before installing any of the features in
this guide, use a grounded wrist strap or touch a safely grounded
object or metal object to avoid damaging them due to static
electricity.
• Turn off the power of your Embedded Computer and allow it to
cool for at least 10 minutes before performing any installation/
uninstallation process.
NOTE: The illustrations in this section are for reference only. The slots
may vary depending on model.
1. Turn off your Embedded Computer, and then disconnect all cables and
peripherals.
2. Place the Embedded Computer on a flat stable surface with its top side
facing down.
3. Remove the screws from the bottom cover, and then remove the
bottom cover.