User Manual
Table Of Contents
- About this manual
- Chapter 1: Getting to know your Embedded Computer
- Chapter 2: Using your Embedded Computer
- Chapter 3: Upgrading your Embedded Computer
- 3.1 Removing the bottom cover
- 3.2 Replacing the bottom cover
- 3.3 Installing a nano SIM card (optional)
- 3.4 Installing an M.2 (E-key) module
- 3.5 Installing an M.2 (M-key) module
- 3.6 Installing an M.2 (B-key) module
- 3.7 Installing antennas (optional)
- 3.8 Installing wall mount brackets (optional)
- 3.9 Mounting to a surface (optional)
- 3.10 Installing DIN rail clips (optional)
- 3.11 Installing the terminal block (optional)
- Chapter 4: Setting up your Embedded Computer
- Appendix
46
PE Series
To install a 4G LTE module:
1. Remove the screw from the M.2 standoff.
2. If the standoff is already seated in the right mounting hole to fit your
4G LTE module, skip to step 4.
3. Unscrew the standoff (A) and install it to a mounting hole that matches
the length of your module (B).
4. Align and insert the module into its slot inside the Embedded
Computer.
5. Gently push down the module on top of the standoff, and then fasten it
using the previously removed screw.