User Manual
Table Of Contents
- About this manual
- Chapter 1: Getting to know your Embedded Computer
- Chapter 2: Using your Embedded Computer
- Chapter 3: Upgrading your Embedded Computer
- 3.1 Removing the bottom cover
- 3.2 Replacing the bottom cover
- 3.3 Installing a nano SIM card (optional)
- 3.4 Installing an M.2 (E-key) module
- 3.5 Installing an M.2 (M-key) module
- 3.6 Installing an M.2 (B-key) module
- 3.7 Installing antennas (optional)
- 3.8 Installing wall mount brackets (optional)
- 3.9 Mounting to a surface (optional)
- 3.10 Installing DIN rail clips (optional)
- 3.11 Installing the terminal block (optional)
- Chapter 4: Setting up your Embedded Computer
- Appendix
48
PE Series
3.7 Installing antennas (optional)
You may install antennas to the six (6) antenna jacks located on the rear
panel. The installed antennas can be connected to a 4G LTE or 5G NR
module installed in the M.2 B-key slot or to a wireless card installed in the
M.2 Wi-Fi slot.
NOTE:
• It is recommended that you install the antennas as shown in the
diagram below.
• 4G LTE/5G NR antennas are flatter and slightly longer than the Wi-Fi
antennas.
Antenna jack locations
For
Wi-Fi
For
4G / 5G