User Manual
Table Of Contents
- About this manual
- Chapter 1: Getting to know your Embedded Computer
- Chapter 2: Using your Embedded Computer
- Chapter 3: Upgrading your Embedded Computer
- 3.1 Removing the bottom cover
- 3.2 Replacing the bottom cover
- 3.3 Installing a nano SIM card (optional)
- 3.4 Installing an M.2 (E-key) module
- 3.5 Installing an M.2 (M-key) module
- 3.6 Installing an M.2 (B-key) module
- 3.7 Installing antennas (optional)
- 3.8 Installing wall mount brackets (optional)
- 3.9 Mounting to a surface (optional)
- 3.10 Installing DIN rail clips (optional)
- 3.11 Installing the terminal block (optional)
- Chapter 4: Setting up your Embedded Computer
- Appendix
50
PE Series
5. Insert the bundled O-ring to the antenna jack (A), then secure the
antenna jack using the bundled hex screw (B).
6. Connect the other end of the RF connector and cable to your wireless
card (refer to Installing an M.2 (E-key) module for details) or to your
4G LTE or 5G NR module (refer to Installing an M.2 (B-key) module for
details).
7. Replace the bottom cover. Refer to Replacing the bottom cover for
details.
8. Screw the external Wi-Fi antennas onto their corresponding antenna
jacks on the rear panel by turning them in a clockwise direction.
9. Position the antennas for optimal signal reception.