User Manual
Table Of Contents
- About this manual
- Chapter 1: Getting to know your Embedded Computer
- Chapter 2: Using your Embedded Computer
- Chapter 3: Upgrading your Embedded Computer
- 3.1 Removing the bottom cover
- 3.2 Replacing the bottom cover
- 3.3 Installing a nano SIM card (optional)
- 3.4 Installing an M.2 (E-key) module
- 3.5 Installing an M.2 (M-key) module
- 3.6 Installing an M.2 (B-key) module
- 3.7 Installing antennas (optional)
- 3.8 Installing wall mount brackets (optional)
- 3.9 Mounting to a surface (optional)
- 3.10 Installing DIN rail clips (optional)
- 3.11 Installing the terminal block (optional)
- Chapter 4: Setting up your Embedded Computer
- Appendix
PE Series
51
3.8 Installing wall mount brackets
(optional)
1. Remove the four (4) rubber feet screws (A), and then remove the rubber
feet from them (B).
2. Align the wall mount brackets to the rubber feet screw holes, and then
secure the wall mount brackets to your Embedded Computer using the
rubber feet screws.