User Manual
Table Of Contents
- About this manual
- Chapter 1: Getting to know your Embedded Computer
- Chapter 2: Using your Embedded Computer
- Chapter 3: Upgrading your Embedded Computer
- 3.1 Removing the bottom cover
- 3.2 Replacing the bottom cover
- 3.3 Installing a nano SIM card (optional)
- 3.4 Installing an M.2 (E-key) module
- 3.5 Installing an M.2 (M-key) module
- 3.6 Installing an M.2 (B-key) module
- 3.7 Installing antennas (optional)
- 3.8 Installing wall mount brackets (optional)
- 3.9 Mounting to a surface (optional)
- 3.10 Installing DIN rail clips (optional)
- 3.11 Installing the terminal block (optional)
- Chapter 4: Setting up your Embedded Computer
- Appendix
52
PE Series
3.9 Mounting to a surface (optional)
You can install your Embedded Computer to a suitable surface using wall
mount brackets.
1. Make sure that the wall mount brackets are already installed. Refer
to the section Installing wall mount brackets for installation
instructions.
2. Secure your Embedded Computer onto your selected surface using
four (4) M3 screws.
8 mm
7.0 mm
Recommended
Screw
Length:
≥ 8.0 mm
Diameter: ≥ 7.0 mm
M3 screw
NOTE:
• The wall mount brackets are compatible with most DIN rail clips
available on the market.
• The rubber feet screws and wall mount bracket screws are the
same screws.