User Manual
Table Of Contents
- About this manual
- Chapter 1: Getting to know your Embedded Computer
- Chapter 2: Using your Embedded Computer
- Chapter 3: Upgrading your Embedded Computer
- 3.1 Removing the bottom cover
- 3.2 Replacing the bottom cover
- 3.3 Installing a nano SIM card (optional)
- 3.4 Installing an M.2 (E-key) module
- 3.5 Installing an M.2 (M-key) module
- 3.6 Installing an M.2 (B-key) module
- 3.7 Installing antennas (optional)
- 3.8 Installing wall mount brackets (optional)
- 3.9 Mounting to a surface (optional)
- 3.10 Installing DIN rail clips (optional)
- 3.11 Installing the terminal block (optional)
- Chapter 4: Setting up your Embedded Computer
- Appendix
PE Series
53
3.10 Installing DIN rail clips (optional)
1. Make sure that the wall mount brackets are already installed. Refer
to the section Installing wall mount brackets for installation
instructions.
2. Align the screw holes on the DIN rail clips to the ones on the wall
mount brackets as shown below.
3. Secure the DIN rail clips to the wall mount using the screws bundled
with the DIN rail clips.
4. Clip the final assembly to a DIN rail by hooking the DIN rail clips to the
top of the DIN rail and then pressing down until you hear the clips snap
into place.