User Manual
Table Of Contents
- About this manual
- Chapter 1: Getting to know your Embedded Computer
- Chapter 2: Using your Embedded Computer
- Chapter 3: Upgrading your Embedded Computer
- 3.1 Removing the bottom cover
- 3.2 Replacing the bottom cover
- 3.3 Installing a nano SIM card (optional)
- 3.4 Installing an M.2 (E-key) module
- 3.5 Installing an M.2 (M-key) module
- 3.6 Installing an M.2 (B-key) module
- 3.7 Installing antennas (optional)
- 3.8 Installing wall mount brackets (optional)
- 3.9 Mounting to a surface (optional)
- 3.10 Installing DIN rail clips (optional)
- 3.11 Installing the terminal block (optional)
- Chapter 4: Setting up your Embedded Computer
- Appendix
PE Series
57
4. Insert the tip of an unfolded paper clip into the force recovery pinhole
(refer to the Left view section for the location), press in, and hold.
5. While holding the paper clip in place, connect the power adapter,
which should automatically power on your Embedded Computer. If it
does not, press the power button.
6. Wait three (3) seconds, and then release the paper clip from the force
recovery pinhole. You should now be in force recovery mode and ready
to flash the OS image.
7. Get the OS image from ASUS, and then unzip the image file to your
host PC.
8. Run the flash script or command file to start the flash process. The flash
process should take a few minutes. Once the flash is completed, your
Embedded Computer will reboot and you should be booted to OS.
NOTE: Refer to the readme file in the unzipped image folder for details
on other items, such as re-flash, recovery, and troubleshooting.