User’s Manual
Table Of Contents
- About this manual
- Chapter 1: Getting to know your Edge Computer
- Chapter 2: Using your Edge Computer
- Chapter 3: Upgrading your Edge Computer
- 3.1 Removing the bottom cover
- 3.2 Replacing the bottom cover
- 3.3 Installing memory modules
- 3.4 Installing 2.5” storage device
- 3.5 Installing the Mini PCIe card
- 3.6 Installing a nano SIM card
- 3.7 Installing an SD card
- 3.8 Installing the wireless card
- 3.9 Installing an M.2 SSD
- 3.10 Installing the antennas (optional)
- 3.11 Installing the USB 2.0 module (on selected models)
- 3.12 Installing the Serial port module (on selected models)
- 3.13 Installing the PoE LAN module (on selected models)
- 3.14 Installing the VESA mount (optional)
- 3.15 Installing the wall mount
- Chapter 4: BIOS Setup
- 4.1 Getting to know your BIOS
- 4.2 BIOS setup program
- 4.3 Main Menu
- 4.4 Advanced menu
- 4.4.1 Trusted Computing
- 4.4.2 PCH Storage Configuration
- 4.4.3 Onboard Devices Configuration
- 4.4.4 ACPI Settings
- 4.4.5 APM Configuration
- 4.4.6 SMART Settings
- 4.4.7 NCT6116D Super IO Configuration
- 4.4.8 NCT6116D HW Monitor
- 4.4.9 Serial Port Console Redirection
- 4.4.10 CPU Configuration
- 4.4.11 AMI Graphic Output Protocol Policy
- 4.4.12 PCI Subsystem Settings
- 4.4.13 USB Configuration
- 4.4.14 Network Stack Configuration
- 4.4.15 SDIO Configuration
- 4.4.16 Platform Trust Technology
- 4.4.17 Security Configuration
- 4.4.18 Thermal
- 4.5 Security
- 4.6 Boot menu
- 4.7 Save & Exit menu
- 4.8 Updating your BIOS
- Chapter 5: Watchdog Timer
- Appendix
PE200S Series
55
3.10 Installing the antennas (optional)
1. Remove the rubber caps from the antenna hole.
2. Prepare the RF connector and cable.
3. Insert the antenna jack end of the RF connector and cable into the
antenna hole from within the chassis outwards.
4. Insert the bundled O-ring to the antenna jack, then secure the antenna
jack using bundled hex screw.
5. Connect the other end of the RF connector and cable to your wireless
card or WWAN card.
6. Repeat steps 1 to 5 to install additional antennas.
You may install antennas to the four (4) antenna holes located on the front
and rear panels. The installed antennas can be connected to a WWAN card
installed in the Mini PCIe slot, or to a wireless card installed in the M.2 Wi-Fi
slot.