User’s Manual
Table Of Contents
- About this manual
- Chapter 1: Getting to know your Edge Computer
- Chapter 2: Using your Edge Computer
- Chapter 3: Upgrading your Edge Computer
- 3.1 Removing the bottom cover
- 3.2 Replacing the bottom cover
- 3.3 Installing memory modules
- 3.4 Installing 2.5” storage device
- 3.5 Installing the Mini PCIe card
- 3.6 Installing a nano SIM card
- 3.7 Installing an SD card
- 3.8 Installing the wireless card
- 3.9 Installing an M.2 SSD
- 3.10 Installing the antennas (optional)
- 3.11 Installing the USB 2.0 module (on selected models)
- 3.12 Installing the Serial port module (on selected models)
- 3.13 Installing the PoE LAN module (on selected models)
- 3.14 Installing the VESA mount (optional)
- 3.15 Installing the wall mount
- Chapter 4: BIOS Setup
- 4.1 Getting to know your BIOS
- 4.2 BIOS setup program
- 4.3 Main Menu
- 4.4 Advanced menu
- 4.4.1 Trusted Computing
- 4.4.2 PCH Storage Configuration
- 4.4.3 Onboard Devices Configuration
- 4.4.4 ACPI Settings
- 4.4.5 APM Configuration
- 4.4.6 SMART Settings
- 4.4.7 NCT6116D Super IO Configuration
- 4.4.8 NCT6116D HW Monitor
- 4.4.9 Serial Port Console Redirection
- 4.4.10 CPU Configuration
- 4.4.11 AMI Graphic Output Protocol Policy
- 4.4.12 PCI Subsystem Settings
- 4.4.13 USB Configuration
- 4.4.14 Network Stack Configuration
- 4.4.15 SDIO Configuration
- 4.4.16 Platform Trust Technology
- 4.4.17 Security Configuration
- 4.4.18 Thermal
- 4.5 Security
- 4.6 Boot menu
- 4.7 Save & Exit menu
- 4.8 Updating your BIOS
- Appendix
76
PE200S Series
4.4.5 APM Conguration
Allows you to congure the Advance Power Management (APM) settings.
ErP Ready
AllowsyoutoswitchosomepoweratS4+S5orS5togetthesystemready
forErPrequirement.Whensetto[Enabled], all other PME options will be
switchedo.
Conguration options: [Disabled] [Enabled(S4+S5] [Enabled(S5)]
Restore AC Power Loss
[S0] The system goes into ON state after an AC power loss.
[S5] The system goes into OFF state after an AC power loss.
[Last State] The system goes into either OFF or ON state, whatever the
system state was before the AC power loss.
Power On By PCI-E
Allows you to enable or disable the wake-on-LAN function for the onboard
LAN controller or other installed PCI-E LAN cards.
Conguration options: [Disabled] [Enabled]
Power On By Ring
[Disabled] Disables the Ring devices to generate a wake event.
[Enabled] Enables the Ring devices to generate a wake event.
Power On By RTC
[Disabled] Disables RTC to generate a wake event.
[Enabled] When set to [Enabled], the items RTC Alarm Date (Days) and
Hour/Minute/Second will become user-congurable with set
values.