User Manual
Table Of Contents
- About this manual
- Chapter 1: Getting to know your Embedded Computer
- Chapter 2: Using your Embedded Computer
- Chapter 3: Upgrading your Embedded Computer
- 3.1 Removing the bottom cover
- 3.2 Replacing the bottom cover
- 3.3 Installing memory modules
- 3.4 Installing 2.5” storage device
- 3.5 Installing an M.2 SSD
- 3.6 Installing a nano SIM card
- 3.7 Installing an SD card
- 3.8 Installing a wireless card to the M.2 slot
- 3.9 Installing an mPCIe / mSATA module
- 3.10 Installing the antennas (optional)
- 3.11 Installing the USB 2.0 module (on selected models)
- 3.12 Installing the Serial port module (on selected models)
- 3.13 Installing the PoE LAN module (on selected models)
- 3.14 Installing the VESA mount (optional)
- 3.15 Installing the wall mount
- 3.16 Installing DIN rail clips (optional)
- Chapter 4: Using the software
- Chapter 5: Watchdog Timer
- Appendix
PE Series
21
3. AT/ATX Mode Conguration jumper
The AT/ATX Mode Conguration jumper allows you to switch between
AT or ATX modes. The default setting for this jumper is set to ATX mode
with a jumper cap attached, to switch to AT mode, remove the jumper
cap.
4. Mini PCIe/mSATA conguration jumper
The Mini PCIe/mSATA conguration jumper allows you to select
between Mini PCIe mode or mSATA mode. Set to pins 1-2 for mSATA
mode, or set to pins 2-3 for Mini PCIe mode.