User Manual
Table Of Contents
- About this manual
- Chapter 1: Getting to know your Embedded Computer
- Chapter 2: Using your Embedded Computer
- Chapter 3: Upgrading your Embedded Computer
- 3.1 Removing the bottom cover
- 3.2 Replacing the bottom cover
- 3.3 Installing memory modules
- 3.4 Installing 2.5” storage device
- 3.5 Installing an M.2 SSD
- 3.6 Installing a nano SIM card
- 3.7 Installing an SD card
- 3.8 Installing a wireless card to the M.2 slot
- 3.9 Installing an mPCIe / mSATA module
- 3.10 Installing the antennas (optional)
- 3.11 Installing the USB 2.0 module (on selected models)
- 3.12 Installing the Serial port module (on selected models)
- 3.13 Installing the PoE LAN module (on selected models)
- 3.14 Installing the VESA mount (optional)
- 3.15 Installing the wall mount
- 3.16 Installing DIN rail clips (optional)
- Chapter 4: Using the software
- Chapter 5: Watchdog Timer
- Appendix
PE Series
47
3.2 Replacing the bottom cover
1. Align the bottom cover with
the screw holes, then replace
the bottom cover onto the
Embedded Computer.
2. Secure the bottom cover
using the four (4) screws
removed previously.
3. Replace the four (4) rubber
feet screws removed
previously.
3.3 Installing memory modules
Your Embedded Computer comes with a SO-DIMM memory slot that allow
you to install a DDR4 SO-DIMM.
Align and insert the memory module into the slot (A) and press it down (B)
until it is securely seated in place.