User Manual
Table Of Contents
- About this manual
- Chapter 1: Getting to know your Embedded Computer
- Chapter 2: Using your Embedded Computer
- Chapter 3: Upgrading your Embedded Computer
- 3.1 Removing the bottom cover
- 3.2 Replacing the bottom cover
- 3.3 Installing memory modules
- 3.4 Installing 2.5” storage device
- 3.5 Installing an M.2 SSD
- 3.6 Installing a nano SIM card
- 3.7 Installing an SD card
- 3.8 Installing a wireless card to the M.2 slot
- 3.9 Installing an mPCIe / mSATA module
- 3.10 Installing the antennas (optional)
- 3.11 Installing the USB 2.0 module (on selected models)
- 3.12 Installing the Serial port module (on selected models)
- 3.13 Installing the PoE LAN module (on selected models)
- 3.14 Installing the VESA mount (optional)
- 3.15 Installing the wall mount
- 3.16 Installing DIN rail clips (optional)
- Chapter 4: Using the software
- Chapter 5: Watchdog Timer
- Appendix
PE Series
59
3.11 Installing the USB 2.0 module (on
selected models)
1. Align the bundled USB 2.0 module with the USB 2.0 port holes and
screw holes on the rear panel.
2. Secure the USB 2.0 module to the rear panel using two (2) bundled
hex bolts and hex nuts.
3. Connect the USB 2.0 module connector to the USB 2.0 connector on
the motherboard.
NOTE: Refer to the Motherboard layout section for the location of the
USB 2.0 connectors.
4. To install another USB 2.0 module, repeat steps 1-3.