User Manual
Table Of Contents
- About this manual
- Chapter 1: Getting to know your Embedded Computer
- Chapter 2: Using your Embedded Computer
- Chapter 3: Upgrading your Embedded Computer
- 3.1 Removing the bottom cover
- 3.2 Replacing the bottom cover
- 3.3 Installing memory modules
- 3.4 Installing 2.5” storage device
- 3.5 Installing an M.2 SSD
- 3.6 Installing a nano SIM card
- 3.7 Installing an SD card
- 3.8 Installing a wireless card to the M.2 slot
- 3.9 Installing an mPCIe / mSATA module
- 3.10 Installing the antennas (optional)
- 3.11 Installing the USB 2.0 module (on selected models)
- 3.12 Installing the Serial port module (on selected models)
- 3.13 Installing the PoE LAN module (on selected models)
- 3.14 Installing the VESA mount (optional)
- 3.15 Installing the wall mount
- 3.16 Installing DIN rail clips (optional)
- Chapter 4: Using the software
- Chapter 5: Watchdog Timer
- Appendix
60
PE Series
3.12 Installing the Serial port module
(on selected models)
1. Align the bundled Serial port module with the Serial port holes and
screw holes on the rear panel.
2. Secure the Serial port module to the rear panel using two (2) bundled
hex screws.
3. Connect the Serial port module connector to the Serial port
connector on the motherboard.
NOTE: Refer to the Motherboard layout section for the location of the
Serial port connectors.
4. To install another Serial port module, repeat steps 1-3.