User Manual
Table Of Contents
- About this manual
- Chapter 1: Getting to know your Embedded Computer
- Chapter 2: Using your Embedded Computer
- Chapter 3: Upgrading your Embedded Computer
- 3.1 Removing the bottom cover
- 3.2 Replacing the bottom cover
- 3.3 Installing memory modules
- 3.4 Installing 2.5” storage device
- 3.5 Installing an M.2 SSD
- 3.6 Installing a nano SIM card
- 3.7 Installing an SD card
- 3.8 Installing a wireless card to the M.2 slot
- 3.9 Installing an mPCIe / mSATA module
- 3.10 Installing the antennas (optional)
- 3.11 Installing the USB 2.0 module (on selected models)
- 3.12 Installing the Serial port module (on selected models)
- 3.13 Installing the PoE LAN module (on selected models)
- 3.14 Installing the VESA mount (optional)
- 3.15 Installing the wall mount
- 3.16 Installing DIN rail clips (optional)
- Chapter 4: Using the software
- Chapter 5: Watchdog Timer
- Appendix
66
PE Series
3.16 Installing DIN rail clips (optional)
1. Make sure that the wall mount is already installed. Refer to the section
Installing the wall mount for installation instructions.
2. Align the screw holes on the DIN rail clips to the ones on the wall
mount as shown below.
3. Secure the DIN rail clips to the wall mount using the screws bundled
with the DIN rail clips.
4. Clip the nal assembly to a DIN rail by hooking the DIN rail clips to
the top of the DIN rail and then pressing down until you hear the clips
snap into place.