TS100-E4/PI2 Pedestal Server User Manual

2-15ASUS TS100-E4/PI2

2.6 Installing 5.25-inch drives

2.6.1 Removing the front panel cover

To remove the front panel cover:

1. Locate and remove two screws

that secure the left side cover

to the chassis. Keep the screw

for later use.

2. Slightly pull the cover toward

the direction of the rear panel

until it disengages from the

chassis. Set the cover aside.

The system comes with four 5.25-inch

drive bays located on the upper front

part of the chassis. An optical drive

that comes standard/optional with

the system package occupies the

uppermost bay (labeled 1). The lower

bays (labeled 2, 3, and 4) are available

for additional 5.25‑inch optical, zip, or

oppy disk drives.

Make sure to unplug the power cable before installing or removing any

system components. Failure to do so may cause severe damage to the

motherboard and other system components!

You must remove the front

panel cover before installing a

5.25-inch drive(s).