User Manual
Table Of Contents
- Mellanox WinOF VPI User Manual
- Table of Contents
- List of Tables
- Document Revision History
- About this Manual
- 1 Introduction
- 2 Driver Features
- 3 Deploying Windows Server 2012 with SMB Direct
- 4 Driver Configuration
- 5 Performance Tuning
- 6 OpenSM - Subnet Manager
- 7 InfiniBand Fabric
- 7.1 Network Direct Interface
- 7.2 part_man - Virtual IPoIB Port Creation Utility
- 7.3 InfiniBand Fabric Diagnostic Utilities
- 7.4 InfiniBand Fabric Performance Utilities
- 7.4.1 ib_read_bw
- 7.4.2 ib_read_lat
- 7.4.3 ib_send_bw
- 7.4.4 ib_send_lat
- 7.4.5 ib_write_bw
- 7.4.6 ib_write_lat
- 7.4.7 ibv_read_bw
- 7.4.8 ibv_read_lat
- 7.4.9 ibv_send_bw
- 7.4.10 ibv_send_lat
- 7.4.11 ibv_write_bw
- 7.4.12 ibv_write_lat
- 7.4.13 ibaddr
- 7.4.14 ibcacheedit
- 7.4.15 iblinkinfo
- 7.4.16 ibqueryerrors
- 7.4.17 ibsysstat
- 7.4.18 perfquery
- 7.4.19 saquery
- 7.4.20 smpdump
- 8 Software Development Kit
- 9 Troubleshooting
- 10 Documentation
TroubleshootingRev 4.3
Mellanox Technologies
113
• Mellanox ConnectX EN 10Gbit Ethernet Adapter <X> device detected that the link connected to port
<Y> is up, and has initiated normal operation.
• Mellanox ConnectX EN 10Gbit Ethernet Adapter <X> device detected that the link connected to port
<Y> is down. This can occur if the physical link is disconnected or damaged, or if the other end-port
is down.
• Mismatch in the configurations between the two ports may affect the performance. When Using
MSI-X, both ports should use the same RSS mode. To fix the problem, configure the RSS mode of
both ports to be the same in the driver GUI.
• Mellanox ConnectX EN 10Gbit Ethernet Adapter <X> device failed to create enough MSI-X vec-
tors. The Network interface will not use MSI-X interrupts. This may affects the performance. To fix
the problem, configure the number of MSI-X vectors in the registry to be at least <Y>.