User Manual
Table Of Contents
- Mellanox WinOF VPI User Manual
- Table of Contents
- List of Tables
- Document Revision History
- About this Manual
- 1 Introduction
- 2 Driver Features
- 3 Deploying Windows Server 2012 with SMB Direct
- 4 Driver Configuration
- 5 Performance Tuning
- 6 OpenSM - Subnet Manager
- 7 InfiniBand Fabric
- 7.1 Network Direct Interface
- 7.2 part_man - Virtual IPoIB Port Creation Utility
- 7.3 InfiniBand Fabric Diagnostic Utilities
- 7.4 InfiniBand Fabric Performance Utilities
- 7.4.1 ib_read_bw
- 7.4.2 ib_read_lat
- 7.4.3 ib_send_bw
- 7.4.4 ib_send_lat
- 7.4.5 ib_write_bw
- 7.4.6 ib_write_lat
- 7.4.7 ibv_read_bw
- 7.4.8 ibv_read_lat
- 7.4.9 ibv_send_bw
- 7.4.10 ibv_send_lat
- 7.4.11 ibv_write_bw
- 7.4.12 ibv_write_lat
- 7.4.13 ibaddr
- 7.4.14 ibcacheedit
- 7.4.15 iblinkinfo
- 7.4.16 ibqueryerrors
- 7.4.17 ibsysstat
- 7.4.18 perfquery
- 7.4.19 saquery
- 7.4.20 smpdump
- 8 Software Development Kit
- 9 Troubleshooting
- 10 Documentation
WinOF VPI for Windows User Manual Rev 4.3
Mellanox Technologies
22
2.7.2 Creating a Load Balancing and Fail-Over (LBFO) Bundle
LBFO is used to balance the workload of packet transfers by distributing the workload over a
bundle of network instances and to set a secondary network instance to take over packet indica-
tions and information requests if the primary network instance fails.
The following steps describe the process of creating an LBFO bundle.
Step 1. Display the Device Manager.
Step 2. Right-click a Mellanox ConnectX 10Gb Ethernet adapter (under “Network adapters” list) and
leftclick Properties. Select the LBFO tab from the Properties sheet.
Step 3. The LBFO dialog enables creating, modifying or removing a bundle.
It is not recommended to open the Properties sheet of more than one adapter simultane-
ously.
Only Mellanox Technologies adapters can be part of the LBFO.