User Manual
Table Of Contents
- Mellanox WinOF VPI User Manual
- Table of Contents
- List of Tables
- Document Revision History
- About this Manual
- 1 Introduction
- 2 Driver Features
- 3 Deploying Windows Server 2012 with SMB Direct
- 4 Driver Configuration
- 5 Performance Tuning
- 6 OpenSM - Subnet Manager
- 7 InfiniBand Fabric
- 7.1 Network Direct Interface
- 7.2 part_man - Virtual IPoIB Port Creation Utility
- 7.3 InfiniBand Fabric Diagnostic Utilities
- 7.4 InfiniBand Fabric Performance Utilities
- 7.4.1 ib_read_bw
- 7.4.2 ib_read_lat
- 7.4.3 ib_send_bw
- 7.4.4 ib_send_lat
- 7.4.5 ib_write_bw
- 7.4.6 ib_write_lat
- 7.4.7 ibv_read_bw
- 7.4.8 ibv_read_lat
- 7.4.9 ibv_send_bw
- 7.4.10 ibv_send_lat
- 7.4.11 ibv_write_bw
- 7.4.12 ibv_write_lat
- 7.4.13 ibaddr
- 7.4.14 ibcacheedit
- 7.4.15 iblinkinfo
- 7.4.16 ibqueryerrors
- 7.4.17 ibsysstat
- 7.4.18 perfquery
- 7.4.19 saquery
- 7.4.20 smpdump
- 8 Software Development Kit
- 9 Troubleshooting
- 10 Documentation
Driver FeaturesRev 4.3
Mellanox Technologies
27
Step 3. Click New to open a VLAN dialog window. Enter the desired VLAN Name and VLAN ID, and
select the VLAN Priority.
Step 4. Verify the new VLAN(s) by opening the Device Manager window or the Network Connections
window. The newly created VLAN will be displayed in the following format:
After installing the first virtual adapter (VLAN) on a specific port, the port becomes dis-
abled. This means that it is not possible to bind to this port until all the virtual adapters
associated with it are removed.
When using a VLAN, the network address is configured using the VLAN ID. There-
fore,the VLAN ID on both ends of the connection must be the same.
Mellanox Virtual Miniport Driver - VLAN <name>